Subwoofer Controller


Posted on Sep 7, 2012

The circuit is completely conventional, and has been around almost forever in one guise or another. Similar circuits were used in the valve (tube) era, so there is nothing new about it. The circuit has already been published on these pages as a guitar tremolo circuit, but fairly obviously, that is not suitable for this purpose. The circuit uses one opamp, but a dual opamp is shown and recommended to ensure that the source impedance is low. If driven from the output of a crossover (opamp based), the impedance will be fine, and the first stage may be omitted.


Subwoofer Controller
Click here to download the full size of the above Circuit.

There is nothing special about the circuit, and a TL072 opamp will be more than adequate for any subwoofer system. VR1 is the phase control pot, and should be linear. No special precautions or close tolerance resistors or caps are needed. The phase switch




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

2x 2,500W RMS stereo amplifier
Sound-modulated light source
Smoke-detector
Sample-and-hold
Ir Pulse To Audio Converter Circuit
The built-in ultrasonic flow measurement of stand pipe based on correlation method is designed (
Lite + Xtall RX V9.0 Schematic
50hz accurate oscillator circuit
Outdoor Garden LED Solar Light Circuit
Simple Infrared Control Extender
simple 12db/octave filter
Precision Triangular-Wave Generator Uses a Single IC
And put the intermodal server preamplifier circuit diagram



Top