Stereo Channels Controller


Posted on Oct 5, 2012

The circuit includes Better channel separation, resulting in an increased stereo effect, as well as reduced noise and hum. This schematic will allow you to cancel or blend left and rigth channels of your stereo. Uses the LM4136 but at the circuit is a 741 opamp. The control potentiometer needs to be a dual ganged center tapped control. As an alternative, a dual ganged switch can be used and appropriate resistors added. See insert with an 12 position switch, each resistor will be a 3k6 ohm resistor. Total resistance = 39K. Other resistors can be used, if ratios remain constant.


Stereo Channels Controller
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Voltage monitor circuit
H bridge circuit
How to implement a soft power switch controllable by microcontroller
Magnetic pickup pre-amplifier circuit
AC Current Monitors
Car Alarm Arming Horn Beep Canceller
Coin Toss Circuit
edm production circuit
880MHz low-noise amplifier application circuit composed of RF2347



Top