Bridge amplifier


Posted on Feb 24, 2013

This circuit is for low voltage applications requiring high power outputs. Output power levels of LO W into 4 ohm from 6 V and 3 V into 8 ohm from 12 V are typical. Coupling capacitors are not necessary since the output dc levels will-be within a few tenths of a volt of each other


Bridge amplifier
Click here to download the full size of the above Circuit.

Where critical matching is required the 500 K potentiometer is added and adjusted for zero dc current flow through the load.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Arduino Blink
0 1000 volt regulated high voltage
led blinking program with pic16f887
Schematics Low-Ripple Power Supply
Baxendall tone control circuit
Mcu Reset And Oscillator Circuits Applicationnote
A simple way of phase locking microwave local oscillators
Micropower thermometer
XTR105 reverse voltage and over-voltage surge protection circuit
OCL power amplifying circuit



Top