Electronic Circuits Schematics Projects




Stereo Equalizer and Balance

Rating: 5.00/10 (41Votes cast)

Category: Audio Circuits / Equalizers
This circuit is also crossed to: , Stereo Circuits
Views: 2144
Rank: 0

This is an image Schematic. No Description available. visit page.

Related circuits

5 band graphic equalizer using a single IC/chip

This circuit uses a single chip, IC BA3812L for realizing a 5 band graphic equalizer for use in hi-fi audio systems.The BA3812L is a five-point graphic equalizer that has all the required functions integrated onto one IC. The IC is comprised of the five tone control circuits and input and output...



5 Band Graphic Equalizer

Another one unit of graphic EQ. five bands. The basic difference with the other circuits is, that I use instead of IC, transistor and the power supply, go up in +/- 24V DC, ensuring low distortion and bigger margins of overloading. With switch S1, we can isolate the EQ. inside or except...



Graphic Equaliser 545

This is an image Schematic. No Description available.



10 Band Graphic Equalizer

The circuit of graphic equalizer, allocates ten adjusting potesometer , that each one from them affects in a predetermined area of frequencies, the central frequency of which abstains a octave (double), from the central frequencies of her neighbouring regions. Each unit has common materials with...



A Pocket Equalizer For Headphone Listening

In audiophile circles, equalizers are prescribed only as a last resort to correct imbalances in recordings and room acoustics for loudspeaker playback. The case for using equalizers with headphones is simply this: headphones by their very nature change the tonal balance of music. The acoustic...



6-Band Graphic Equalizer

This project is based on a 10 band October 1977 project from ETI (Electronics Today International). The center frequency of each band is determined by 2 caps, CA and CB. The schematic shows a table with values of CA and CB for various the center frequencies. This layout is for a 6 band...



Equalization Circuit

2 versions of the equalization circuit, the first having 6 db less insertion loss than the other. However, some may not be able to find a .68 microfarad capacitor. The second version uses a more common .22 microfarad capacitor. Both of these circuits operate to reduce the frequencies above 2 kHz...



10 Band Audio Equalizer

This circuit allows you to equlize the audio signals in ten band. It uses low cost op-amps to form a professional equalizer circuit. The heart of the design is a classical band-pass active filter. The U11 acts as an attenuator to prepare the signal level for equlizing. The U13 acts as a final...



Telephone Electronics: "Theory of Simplex and Phantom Circuits: Balanced Cond...

Electronics: "Basic Amplifiers" pt1-2 1963 US Army Training Film


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits