Electronic Circuits Schematics Projects




Mini Microphone preamplifier

Rating: 9.00/10 (86Votes cast)

Category: Audio Circuits / Microphone Circuits
Views: 3315
Rank: 0

This preamp is very simple, and will work under tough conditions. The input impedance is pretty high, so it won`t load down electric guitars. It will also amplify microphones. When I have a moment, I`ll make some additions that will optimize it for microphones, and also show how to power a condenser microphone.The power source is typically a 9-volt battery, but the circuit will tolerate 6 to 30 volts. Battery drain at idle is about 1 milliamp. The two red LEDs are important in the circuit - they act as a voltage reference to set the operating point of the opamp visit page.

The power source is typically a 9-volt battery, but the circuit will tolerate 6 to 30 volts. Battery drain at idle is about 1 milliamp. The two red LEDs are important in the circuit - they act as a voltage reference to set the operating point of the opamp http://www.bobblick.com/techref/projects/preamp/preamp.html

Related circuits

741 Microphone amplifier

This preamplifier uses a type of IC 741, and can boost a microphone signal to line level. The microphone signal is connected to the "input" put. Any power for the microphone jack of the "food" are met. Here half the supply voltage. Using the gain potentiometer P1 can be adjusted from 10 to 101...



Microphone amplifier

This circuit operates from



Audio Perimeter Monitor

Using a single cable such as speaker wire or doorbell cable, this circuit can be remotely positioned, for example, at the bottom of a garden or garage, and used to detect all sound in that area. The cable can be buried in a hosepipe or duct and is concealed out of sight. The mic is an...



Microphone preamplifier with TLC251

A microphone preamplifier using: om CMOS op amp with its own battery, is small enough to be placed in a case of small microphone. The amplifier operates from a 1.5V battery cathode mercury low supply currents. This preamp will operate at very low power and maintain a reasonable frequency response...



Microphone Preamp

This circuit is used to interface a high-impedance microphone to a radio transceiver that requires a low-impedance microp



POP free mic on/off circuit

This circuit uses a simple technique to eliminate the usual pop sound when an electret type microphone is switched on or off. It is completely passive and will work on dynamic and electret type microphones.



Mic Circuit Test Oscillator

The first stage is the oscillator itself. This is a simple three stage phase shift oscillator - a circuit that is remarkably uncommon - which is to say I have never seen it used elsewhere. I designed it for another project a few years ago, and I don`t understand why it is not in any opamp...



Low Noise Microphone Preamp

This is a design for a low noise microphone preamplifier, which is ideally suited to low impedance (600 Ohm nominal) microphones. It is most regrettable that good mic transformers are rather hard to come by, and are expensive. If you happen to have a suitable one in your junk box, give it a try...



CDC ElEcTroNic Work Shop - 741 Opamp based Mic Preamp.avi

What is an op amp? Operational Amplifier tutorial & super spy microphone circ...


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits