4 lines Stereo Mixer

Posted on Jul 1, 2012

With this circuit you can mix four separate audio inputs. Each input will accept high or low impedance microphones, phonograph, tape or aux signals. You can adjust the gain of each input by adjusting each respective pot. With the Stereo/Mono switch you can combine just inputs 1,2 and 3,4 or in the Mono position combine all four inputs.

4 lines Stereo Mixer
Click here to download the full size of the above Circuit.

Signal response is 20 Hz. to 20kHz. with very high input impedance and very low distortion with complete output short circuit protection. This circuit will drive any power amp with an input impedance of 2,000 ohms.

Leave Comment

characters left:

New Circuits



Popular Circuits

Infrared transmitter
Li Ion Battery Charger Circuit Using IC LP2951
Simple MD Catridge Preamplifier
Unipolar Stepper Motor Controllers
An op-amp made from 555 chips
555 tri-state acousto-optical logic circuit
INA331 332 configured to directly drive the capacitive input A D converter circuit