6 Input Mixer


Posted on Jul 29, 2012

The mixer circuit below has 3 line inputs and 3 mic inputs. The mic inputs are suitable for low impedance 200-1000R dynamic microphones. An ECM or condenser mic can also be used, but must have bias applied via a series resistor. As with any mixer circuit, a slight loss is always introduced. The final summing amplifier has a gain of 2 or 6dB to overcome this. The Input line level should be around 200mV RMS. The mic inputs are amplified about 100 times or by 40dB, the total gain with the mixer is 46dB. The mic input is designed for microphones with outputs of about 2mV RMS at 1 meter. Most microphones meet this standard.


6 Input Mixer
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

PIC16CS4 Programmer
Pwm motor speed control
Ir Detector
Compact 3-in-1 Stripboard DIYduino with Integrated Sensor and L298N Motor Shield
6.9 GigaHertz Chrono PC-based
Voltmeter Ammeter
Super Reverb circuit
free electronics circuit diagram
Wein Bridge Oscillator using ic 741 op amp
Digital frequency counter
mini light
Water Meter Monitor
Emitter-Coupled LC Oscillator
Bedini Self Oscillator High Voltage Output
TV signal amplifying circuit diagram conversion



Top