Audio Line preamp Driver


Posted on May 12, 2012

This preamplifier has a low output impedance, and is designed to drive long cables, allowing you to listen to a remote music source without having to buy expensive screened cables. The very low output impedance of around 16 ohms at 1KHz, makes it possible to use ordinary bell wire,loudspeaker or alarm cable for connection.


Audio Line preamp Driver
Click here to download the full size of the above Circuit.

The preamplifier must be placed near the remote music source, for example a CD player. The cable is then run to a remote location where you want to listen. The output of this preamp has a gain of slightly less than one, so an external amplifier must be us




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Square-wave-pulse-extractor
Solid State Relay Required Only 50uA Drive Current
schematics Control speed of Nidec fan
Water Level Sensor Circuit Using LM1830 Single Chip
rf mod
A Power Management Interface Circuit For Telecom Hot Swap With Local Dc/dc Conve
vary Precise Lc Meter
Strobe Flash Light Circuits
Homebuilt Hellschreibers
Using voice switch circuit relay lighting
Multifunction adjustable universal time relay (NE555, CD4013) circuit
High operating voltage regulator circuit diagram



Top