Microphone pre-amp


Posted on Sep 1, 2012

This circuit is used to give out a microphone preamp to a amplifier which will power the signal. The NPN transistors used are ECG123A. This circuit is also a older model to the one that now use IC's, but dont worry this will still work fine.


Microphone pre-amp
Click here to download the full size of the above Circuit.

It's output is as clean as a whistle. Remember the output cannot drive a speaker because is a preamplifier and only an amplifier can give an output for speaker. Any microphone can be used here. If you want you can put a LED light at the 12Volt input, but don't forget to put a 470k resistor in seties.





Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

H2 PWM Generators
AVR Programmer with ATMega8-16
Remotely-adjustable-solid-state-high-voltage-supply
Fm-snooper
Sensitive Continuity Checker
DIY Sound Activated LightsCircuit
Frequency/Tone Decoder Circuit Using TC9400 FVC
automatic night lamp 230v
Decibels Meter Circuit Using LM324
Fluid Level Detector Circuit PCB
I ran a code on my 99 dodge ram 1500 and it came back with
Autodyne Circuit
LED Light Pen
dual slope sampling SE



Top