RIAA preamplifier CA3410


Posted on Mar 26, 2013

This circuit has read the RIAA equalization, tone controls, and adequate gain to drive most power amplifiers conunercial by using CA3410 op amp BiMOS. Total harmonic distortion, pushed to provide an output of 6-V, is less than 0.035% in audio-frequency range from 150 Hz to 40 kHz.



RIAA preamplifier CA3410 - image 1
Click here to download the full size of the above Image.

Full stereo preamp is to duplicate this circuit using the CA3410 remaining two amplifiers.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Panner Waveform Generator
    Sobriety Tester with LM3914
    Ultrasonic switch circuit
    Stereo balance tester
    3-30V 3A Adjustable Regulated DC Power Supply
    simple mixer schematic
    Simple Analogue Electronic Key
    One-Wire Serial Bus Carries Isolated Power And Data
    Field-strength meters
    Phase Delay Network for 3D Audio Enhancement
    1999 Pontiac Montana: console temperature MPG compass etc. failed
    Tesla HV Coil



    Top