Servo tester with PIC12F675


Posted on Jul 17, 2012

This is a simple servo tester which will comprehensively test the capabilities of almost any modern servo. It has two pushbuttons, CENTRE and SWEEP and a potentiometer which works as follows: - CENTRE Does exactly that, centers the servo, afterwards the potentiometer determines position. - SWEEP Sweeps the servo back and forth at a rate determined by the potentiometer setting. The PIC uses its internal timer to set up a constant frame duration of 20ms and the on/off ratio is set by the user.


Servo tester with PIC12F675
Click here to download the full size of the above Circuit.

Parts: R1 = 1K R2 = 10K R3 = 82R R4 = 10K R5 = 5K potentiometer C1 = 27pF C2 = 27pF C3 = 100nF D1 = 4,7V zener diode Q1 = 10MHz crytal IC1 = PIC12F675




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Oscillator-clock-generator
learning Arduino programming
Ultrasonic Remote Control Circuit
schematics Control speed of Nidec fan
Basswave amplifier
Homemade tablet CarPC
Beginning Embedded Electronics - 1
Detected line current Phase protective circuit 2
Burglar alarm bell



Top