G STRAIN ENERGY ABSORBER

  
It is important to know that transistors Q1,Q2,Q3 must not work like an astable (tri-phase) multivibrator (you could verify it on scope (no square waves but NON LINEAR wave between XB, YB, ZB must be displayed on the scope).
G STRAIN ENERGY ABSORBER - schematic

The transistors used have gain between 35-40, it is important to notice that the transistor gain must be low (< 70 ). To succeed your G Strain absorber circuit, you must have transistor gain (hfe) approximately equal. The power supply must be a high po



Leave Comment

characters left:

New Circuits

.