Sensor-Activated Relay Pulser Circuit

Posted on Jun 16, 2012

A sensor turns on Ql to activate the low-frequency 555 oscillator, which pulses LAMP II. Sensor may be sensitive to changes in light or temperature. Either RA or RB can be sensors, as desired. A decrease in RB or an increase in RA will cause the NE555 to flash M.

Sensor-Activated Relay Pulser Circuit
Click here to download the full size of the above Circuit.

fl and RB should be 100 kohm max.

Leave Comment

characters left:

New Circuits



Popular Circuits

Balanced microphone preamp project
5-Pole Low-Pass Filter Circuit
Ultrasonic Pest Repeller Circuit
pcb Driving 10x10 LED matrix with AVR
Arduino Runing On && Charging NiMH batteries
Hard Disk Switch
Mini GSM localizer without GPS
Burglar alarm circuit
Based on AT89C52 minimum system interface circuit