Electronic Circuits Schematics Projects




IR Remote Control Extender Circuit (Mark 3)

Rating: 2.00/10 (18Votes cast)

Category: Automation Circuits / Remote Control
This circuit is also crossed to: Astable , Timer Circuits
Views: 4717
Rank: 0

IR appliances use pulses (control signals) sent over a modulated IR carrier wave. The carrier wave may be modulated at various frequencies, 36-38KHz being the most popular.Some Satellite receivers use even higher frequencies than this. The IR1 remote module receives an infra red signal and separates control pulses from the modulation. To re-transmit, a 555 timer is configured as an astable oscillator. visit page.

Related circuits

Magnetic-Radiation Remote-Control

These units can be useful as a short-range, single-channel remote-control. When the pushbutton in the transmitter circuit is briefly activated, the LED D1 in the receiver illuminates and an optional beeper or relay can be operated. Circuit operation is based on a non-modulated 35KHz frequency...



IR repeater with 555 timer

The signal emitted by an IR remote control contains two parts, the control pulses and a modulated carrier wave. The control pulses are used to modulate the carrier, a popular modulation frequency being 36 and 42KHz. The signal is radiated by an IR diode, typical wavelengths in the 850 and 950 nm...



IR Remote Control Tester

As I was developing my IR Extender Circuit, I needed to find a way of measuring the relative intensities of different Infra red light sources. This circuit is the result of my research. I have used a photodiode, SFH2030 as an infra red sensor. A MOSFET opamp, CA3140 is used in the differential...



Four/Five Channel RC Cars

This transmitter has no separate on/off switch because the joysticks switch the battery terminal. There are two speeds in forward and one in reverse. The receiver has a bigger motor to drive the wheels and a smaller motor to drive the steering which is not proportional. You could add an extra...



Radio Remote Control using DTMF Circuit

Here is a circuit of a remote control unit which makes use of the radio frequency signals to control various electrical appliances. This remote control unit has 4 channels which can be easily extended to 12. This circuit differs from similar circuits in view of its simplicity and a totally...



Infrared Remote Control ( 555 / 4013 / 4093 )

This circuit will allow you to turn on any piece of equipment that operates on 115 volts ac. The receiver circuit is based on the Radio Shack infrared receiver module (MOD), part number 276-137. It is also available from some of the other sources listed on my Links page. The MOD accepts a 40khz...



INFRARED REMOTE CONTROL TIMER

This infrared remote control timer can be used to turn an appliance on/off for a period of 0.11 second to 110.0 seconds. The circuit comprises two sections, namely, the transmitter section and the receiver section. Fig. 1 shows the IR transmitter section. The astable multivibrator NE555 (IC1) is...



SMS control 4 way remote control relays

With this circuit we can controll up to 8 devices (4 devices in our example project), by sending a specific SMS message with any mobile phone. Its very usefull at the cases that, at the place we have the devices, we have not a wired telephone line. If you have an old ericsson mobile phone and you...



HDMI + IR / Digital Optical Audio (Bi-directional) over Cat Extender (Octava)

Remote


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits