Servo motor Tester with PIC12F675


Posted on May 4, 2012

This is a simple servo tester which will comprehensively test the capabilities of almost any modern servo. It has two pushbuttons, CENTRE and SWEEP and a potentiometer which works as follows: CENTRE Does exactly that, centers the servo, afterwards the potentiometer determines position. SWEEP Sweeps the servo back and forth at a rate determined by the potentiometer setting. The PIC uses its internal timer to set up a constant frame duration of 20ms and the on/off ratio is set by the user.


Servo motor Tester with PIC12F675
Click here to download the full size of the above Circuit.

Parts List R1 = 1K R2 = 10K R3 = 82R R4 = 10K R5 = 5K potentiometer C1 = 27pF C2 = 27pF C3 = 100nF D1 = 4,7V zener diode Q1 = 10MHz crytal IC1 = PIC12F675




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Relay driver
Battery Charger
Reset Protection For Computers
Audio IC TA8215 based on 15W Car Audio Amplifier
Human-Computer Interface Technology 1
Flyback Power Supply Powers Subscriber Line Interface Circuit
Servicing the Gottlieb System 1 pinball game
Scoobas Solution Sensing Tactic
gsm gps based vehicle theft control
clap switch
500W Low Cost 12V to 220V Inverter
Bgb707l7esd As An Fm Radio Antenna Lna
CXG1024N High-frequency Spdt Antenna Switch
The Link 4+0 ?– Internal Intercoms
Automobile White LED Light
interfacing lcd atmega32 microcontroller atmel studio
Fuse Saver
Infrared remote control receiver for Media Centers
5V / 2A isolated switching power supply circuit diagram
Time base using a delay circuit touch lamp
XTR108 reverse voltage and overvoltage protection circuit diagrams



Top