1MHZ Digital Frequency Meter


Posted on Feb 6, 2014

This circuit is a frequency meter, low cost. It covers region 1HZ until 1MHZ. The IC1 schmitt trigger that it regulates the signal of entry and him changes in reasonable level suitable for the IC2-3-4. With the tenth pulse in the entry of IC2/1, is produced a pulse `` carry `` in the IC3/5. The same moment the IC2 causes the depiction in the DIS1,


1MHZ Digital Frequency Meter
Click here to download the full size of the above Circuit.

show [0], the IC3 causes the DIS2, to show [ 1 ]. When in the entry of IC3 it reaches and the tenth pulse, the DIS2 show [ 0 ] and the DIS3 show [ 1 ], (with total depiction 100, having the display in right order). The exit `` carry`` off IC4/5, can be used in order to it turns on the decimal point (comma) the DIS1, in order to it shows a situation over the limits of measurement. The timed begins with the one of half double timer (IC5A). Switch S1 select the interruption the time in 1sec or in 1ms. At the duration of this interruption, second half the (IC5B), it produces a interruption of depiction 2 or 3sec. , at the duration which counter cut off by the entry and the displays remain OFF. In the end of depiction, a pulse RESET, begins the interruption of time/depiction. The critical point is round the Q1-IC1, which should be placed as long as it becomes more near in the jack of entry, to reject of parasitic signals of high frequency. For the regulation, we can use a frequency meter good precision (if you do not have you are lented) and a generator of signal. We put switch S1, in place [HZ], we apply in the entry a low frequency and we regulate the trimmer TR2, so that we take the right clue, which should suit with source frequency meter. We repeat also the regulation for the department of KHZ, with a higher frequency. The supply of circuit becomes with a battery +9V, if it is used as portable or from suitable power supply...




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Wien-Bridge Oscillator Using HA2541 Op-Amp
24W amplifier using TDA1516
Low Power 12V Transformerless Power Supply
SA2132 AM/FM RADIO RECEIVER
Speech Board for SPO256
Negative Voltage Hot Swap Controllers in SOT-23
Tuned radio frequency receiver
Ultrasonic Dog Whistle
50hz Calibration aid for Multimeters
Motorcycle ignition circuit diagram



Top