5 to 30 Minute Timers


Posted on Feb 6, 2014

Simple to build, simple to make, nothing too complicated here. However you must use the CMOS type 555 timer designated the 7555, a normal 555 timer will not work here due to the resistor values. Also a low leakage type capacitor must be used for C1, and I would strongly suggest a Tantalum Bead type. Switch 3 adds an extra resistor in series to the


5 to 30 Minute Timers
Click here to download the full size of the above Circuit.

timing chain with each rotation, the timing period us defined as :- Note that R1 has a value of 8. 2M with S3 at position "a" and 49. 2M at position "f". This equates to just short of 300 seconds for each position of S3. C1 and R1 through R6 may be changed for different timing periods. The output current from Pin 3 of the timer, is amplified by Q1 and used to drive a relay.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Oscilloscope AC Probe
    Telephone blinker
    sensor Arduino analog signal read problem
    fm oscillator with bly87
    High And Low Voltage Cut Off With Time Delay
    Audio Amplifiers
    32kHz clock oscillator circuit
    XTR105 reverse voltage and over-voltage surge protection circuit
    DC panel battery uninterrupted power supply switching circuit



    Top