500w-power-amplifier-with-2sc2922.html


Posted on Feb 6, 2014

This amplifier has Output power about 500 Watt with the compatible voltage supply is under 63 Volt or same. If this amplifier operated the transistor output recomended to be place on the good heatsink. Because, the transistor will be hot. Transistor Ouput using SANKEN 2SC2922 and 2SA1216. Below describe the Circuit Diagram of 500W Power Amplifier


500w-power-amplifier-with-2sc2922.html
Click here to download the full size of the above Circuit.

: Could you repeat that can occur made to add to offered audio power amplifier The answer is either decrease load impedance otherwise increase supply voltage. The drop the impedance, the extra current is wanted, making the construction of low impedance output stages other testing (at hand are selected other matter-of-fact limits), so consent to`s increase supply voltage.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    The 25-30kV DC Generator
    Wireless Data Communication system
    HAM Modulation Monitor
    40 meters CW Transceiver
    Class A 40W into 8 Ohms Amplifier
    Remote control by mobile phone
    LM139 Measure delay generator Schematic Diagram
    Solar to 6V Batt to LED emergency light circuit
    the water level control system design of the one-chip computer
    Water Activated Sensor Alarm Using 555 PCB
    TDA2030 200 watt amp low cost audio power amplifier
    Build an Experimenters Power Supply
    SR 6m/2m Converter
    Counter circuit diagram of the digital circuit



    Top