Another RF Field Strength Meter


Posted on Feb 4, 2014

This circuit is another radio frequency (rf) field strength meter, similar with our previous field strength meter circuit, but with lower supply voltage (only a single cell 1. 5V battery). Here is the schematic diagram of this rf strength meter circuit: To use, turn on transmitter and meter; adjust C1 for peak reading. Turn off transmitter and adju


Another RF Field Strength Meter
Click here to download the full size of the above Circuit.

st R1 for a perfect zero reading on the meter. Turn on transmitter (with no audio modulation) and go to your monitor point(s) and take readings. Your monitor point(s) should be many meters/yards away from your antenna, but obviously must be where the signal is still strong enough to register on your instrument. After taking a set of readings, you can experiment with your antenna or transmitter system, then take another set of readings and determine whether your signal strength was increased or diminished. Keep your readings in your engineering logbook. Make note of whether it`s been dry or rainy in recent days; moist soil might give slightly better propagation.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    FM transmitter with two 2N3904
    Charger Extends Lead-Acid Battery Life
    From Crystal Sets To 405 Line television
    adding audio to arduino projects
    ultrasonic cleaning transducers series parallel
    Embedded Development on OSX
    Single-button control off of the relay circuit 2
    CJ-12 Excitation circuit transfer machine
    Flooding rats Electronic cat
    Sequential Actuator for powering up to four devices



    Top