Audio Voice-Over Circuit PCB


Posted on Feb 7, 2014

This is a circuit where a microphone and preamp circuit (voice circuit) have priority over any other audio signal. You can think of this as a one way intercom, if the main amplifier is used for listening to music, then when the push to talk switch is pressed, the amplifier is switched to the voice signal. In its simplest form, a voice-over unit is


Audio Voice-Over Circuit PCB
Click here to download the full size of the above Circuit.

just a microphone and change-over switch feeding an amplifier, the output from the microphone having priority over the amplifiers audio signal when the "push-to-talk" switch is pressed. In this circuit, a preamplifier immediately follows the microphone and is designed to be used some distance away from the main amplifier. The changeover switch is nothing more than a relay with a single changeover contact. For completion, an amplifier based on the LM380 is shown. Three wires are needed to connect the remote microphone unit to the amplifier and switching unit. With reference to the above schematic, the two BC109C transistors are used to make a microphone preamplifier. The left hand BC109C operates in common emitter mode, the right hand emitter follower. The combination form a high gain, low output impedance amplifier, capable of driving a long audio cable. Screened cable is not required as the output impedance from the microphone pre-amp is very low, and will be immune to mains hum and background noise. The input is shown as a three wire Electret Condenser Microphone though two wire ECM`s may also be used. The output of the pre-amp is via a 100uF capacitor and 1k resistor. The 1k resistor here plays an important role, eliminating the dc component of the audio output. (See also eliminating the DC "thump" also on this web site. ) A cable of three or more wires is wired to the remote amplifier. The amplifier shown here is based...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    The KD2BD ATV AM Video Modulator
    Electronic Gong Circuit
    AD8195 and DDC buffers
    Radio Frequency Circuits
    IR Harp
    High Power Solid State Amplifier
    Blood pressure sensing circuit diagram BP01-type pressure sensor



    Top