Automatic Electronic Emergency Light Circuit Low Cost


Posted on Feb 5, 2014

The circuit comprises two sections: charger power supply and LED driver. The charger power supply section is built around 3-terminal adjustable regulator (IC1) LM317, while the LED driver section is built around transistor BD140(T2). In the charger power supply section, input AC mains is stepped down by transformer to deliver 9V, 500mA to the bridg


Automatic Electronic Emergency Light Circuit Low Cost
Click here to download the full size of the above Circuit.

e rectifier, which comprises diodes (IN4007x4). Filter capacitor (25v/1000uf)eliminates ripples. Unregulated DC voltage is fed to input pin 3 of IC1 and provides charging current through diode IN4007(D5) and limiting resistor (16ohm)R16. By adjusting preset 2. 2K(VR1), the output voltage can be adjusted to deliver the required charging current. When the battery gets charged to 6. 8V, zener diode conducts and charging current from regulator (IC1) finds a path through transistor BC547(T1) to ground and it stops charging of the battery. The LED driver section uses a total of twelve 10mm white LEDs. All the LEDs are connected in parallel with a 100-ohm resistor in series with each. The common-anode junction of all the twelve LEDs is connected to the collector of pnp transistor T2 and the emitter of transistor T2 is directly connected to the positive terminal of 6V battery. The unregulated DC voltage, produced at the cathode junction of Bridge(Diodes), is fed to the base of transistor T2 through a 1k resistor. When mains power is available, the base of transistor T2 remains high and T2 does not conduct. Thus LEDs are off. On the other hand, when mains fails, the base of transistor T2 becomes low and it conducts. This makes all the LEDs (LED1 through LED12) glow. The mains power supply, when available, charges the battery and keeps the LEDs off as transistor T2 remains cut-off. During mains failure, the charging section stops...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    DIGITAL LED AMMETER
    Amplifier Clipping Indicator
    LCD monitor Switched Mode Power Supply
    1.3 - 32 V / 5A Power Supply with Short Circuit Protection with LM338
    Lamp Flasher
    H-bridge circuit
    USB PICKit2 programmer
    Irregular Flasher
    How to make a solar powered robot
    Optical attenuation control circuit
    Multi-point control corridor lights circuit



    Top