Basic UPS PCB


Posted on Feb 5, 2014

This circuit is a simple form of the commercial UPS, the circuit provides a constant regulated 5 Volt output and an unregulated 12 Volt supply. In the event of electrical supply line failure the battery takes over, with no spikes on the regulated supply. This circuit can be adapted for other regulated and unregulated voltages by using different re


Basic UPS PCB
Click here to download the full size of the above Circuit.

gulators and batteries. For a 15 Volt regulated supply use two 12 Volt batteries in series and a 7815 regulator. There is a lot of flexibility in this circuit. TR1 has a primary matched to the local electrical supply which is 240 Volts in the UK. The secondary winding should be rated at least 12 Volts at 2 amp, but can be higher, for example 15 Volts. FS1 is a slow blow type and protects against short circuits on the output, or indeed a faulty cell in a rechargeable battery. LED 1 will light ONLY when the electricity supply is present, with a power failure the LED will go out and output voltage is maintained by the battery. The circuit below simulates a working circuit with mains power applied: Between terminals VP1 and VP3 the nominal unregulated supply is available and a 5 Volt regulated supply between VP1 and VP2. Resistor R1 and D1 are the charging path for battery B1. D1 and D3 prevent LED1 being illuminated under power fail conditions. The battery is designed to be trickle charged, charging current defined as D2 must be included in the circuit, without D2 the battery would charge from the full supply voltage without current limit, which would cause damage and overheating of some rechargeable batteries. An electrical power outage is simulated below: The ability to maintain the regulated supply with no electrical supply depends on the load taken from the UPS and also the Ampere hour capacity of the battery. If you were...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Infrared transmitter
    Low pass filter for Subwoofers
    Phase sequence detector
    Audio-power-amplifier
    Fm Demodulator Circuit
    90-125 Mhz Crystal RF Oscillator
    LED Brake/Rear Light Specifically for motorcycles Circuit diagram
    Use Analog Techniques To Measure Capacitance In Capacitive Sensors
    PIC Current Limiter
    am transmitter circuit
    Lambda Probe Readout For Carburettor Tuning
    Audio Filters Circuits Projects
    Low-Frequency Crystal Controlled Oscillator
    Yaesu G-400 Antenna Rotator Controller
    LM2876 amplifier configuration



    Top