Battery charger circuit using L200


Posted on Feb 7, 2014

A very simple battery charger circuit having reverse polarity indication is shown here. The circuit is based on IC L200. L200 is a five pin variable voltage voltage regulator IC. The charging circuit can be fed by the DC voltage from a bridge rectifier or center tapped rectifier. Here the IC L200 keeps the charging voltage constant. The charging curr


Battery charger circuit using L200
Click here to download the full size of the above Circuit.

ent is controlled by the parallel combination of the resistors R2 & R3. The POT P1 can be used to adjust the charging current. This circuit is designed to charge a 12 V lead acid battery. The transistor t1, diode D3 and LED are used to make a battery reverse indicator. In case the battery is connected in reverse polarity, the reverse polarity indicator red LED D5 glows. When the charging process is going on the battery charging indicator green LED D4 glows.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    0-15 Volt Tracking PS
    Low Power consumption 5V regulator circuit
    Automatic mooring light
    Speed alarm
    Fm Radio Transmitter Circuit
    PIC 16F88 Digital Thermometer Light Meter and resistance ohm meter
    electronic doorbell circuit
    10.58 to 10.74 mhz vfo oscillator circuit
    Battery Tester Circuit Schematic
    In-Cab Winch Controls and Winch Power Disconnect
    A non-isolated DC/DC converter circuit diagram



    Top