Brake lights flasher circuits


Posted on Feb 6, 2014

This circuit will allow the brake light was flashing. The default behavior. When the power supply to the circuit, Or tap the brake it. The IC timer IC2 drive current to transistor Q2 and producing oscillator output, pulse signal output at pin 3 to input pin 1 of IC1-CD4024. Count pulse and stops counting after 8 pulses, with pin 2 of IC1 is reset. N


Brake lights flasher circuits
Click here to download the full size of the above Circuit.

ow, tap and hold the brake, the brake lights will flash the set, about 6 times per second. Which is determined by R3 and C3. The distance between each set, is defined by the C2 and R1. The Voltage input to the circuit, used 12 volt DC power from a car at all. The section capacitor C1 as a filter to smooth the flow. Transistor Q2 may be any number SM3180.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Fast Low Duty-Cycle Pulse Oscillator
    IR Demodulator
    operational amplifier op amp oscillator
    Real Time Clock Using AT89C4051
    SPI-Flash Programmer 3.7
    simple garage stop light circuit
    simple key-scan IC



    Top