Car Headlights Timer Circuit Schematic


Posted on Feb 5, 2014

This device is a simple timer, allowing to keep on the headlights of your vehicle for about 1min. and 30sec. , e. g. when accessing some dark place, without the necessity of coming back to switch-off the lights. Pushing on P1 allows C1 charging to full 12V battery supply. Therefore Q1 is driven hard-on, driving in turn Q2 and its Relay load. The hea


Car Headlights Timer Circuit Schematic
Click here to download the full size of the above Circuit.

dlights are thus activated by means of the Relay contact wired in parallel to the vehicle`s headlights switch. RL1 remains activated until C1 is almost fully discharged, i. e. When its voltage falls below about 0. 7V. The timing delay of the circuit depends by C1 and R1 values and was set to about 1min. and 30sec. In practice, due to electrolytic capacitors wide tolerance value, this delay will vary from about 1min. and 30sec. to 1min. and 50sec. An interesting variation is to use the inside lamp as a command source for the timer. In this way, when the door is opened C1 is charged, but it will start to discharge only when the door will be closed, substituting pushbutton operation. To enable the circuit acting in this way, simply connect the cathode of a 1N4002 diode to R1-C1 junction and the anode to the "live" lead of the inside lamp. This lead can be singled-out using a voltmeter, as it is the lead where a 12V voltage can be measured in respect to the vehicle frame when the lamp is on.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    WAH & FUZZ Guitar circuits
    Modern FM Converter
    Digital Vacuum Gauge
    16 G— 2 LCD Volt Meter & Ampere Meter With PIC Schematic Diagram
    Build an IR Beam Breaker
    pendulum controlled clock
    Gas Generator Voltage Control Circuit
    powering circuit using serial port
    automatic garden light controller system
    Motion Detector Alarm Circuit
    Mains Manager
    ZN414 portable Receiver
    Simple adjustment of high input impedance double wave linear detection circuit RC4558DN



    Top