Condenser Pre Amplifier LM 1458

Posted on Feb 5, 2014

Using a LM1458 dual op amp IC. The circuit takes the audio signal rom the condenser microphone and amplifier it, so you can use the microphone as the input to some device which wouldn`t normally accept microphone level signals. The circuit requires a 6-9 volt supply. Output of the microphone amplifier can be made variable by connecting a 10k © po

Condenser Pre Amplifier LM 1458
Click here to download the full size of the above Circuit.

tentiometer. Circuit`s gain can be increased by men perbesar the value of 47K, depending on the input sensitivity of the main amplifier system. The microphone should be housed in a small round enclosure.

Leave Comment

characters left:

New Circuits



Popular Circuits

Inverters form three-phase VCO
Antenna ground loop Isolator
Vacuum Tube Preamplifier Analysis and SPICE Simulation
Electronic Voltmeter Ammeter Circuit Using Single IC 741
burning hex files using usbasp
stepper motor controller circuit and code
40 PIN AVR Development Board
Dimming Control Circuit for LEDs
Cutting good performance signal switching circuit