Connection Testers


Posted on Feb 5, 2014

This simple circuit uses a 741 op-amp in differential mode as a continuity tester. The voltage difference between the non-inverting and inverting inputs is amplified by the full open loop gain of the op-amp. Ignore the 470k and the 10k control for the moment, and look at the input of the op-amp. If the resistors were perfectly matched, then the vo


Connection Testers
Click here to download the full size of the above Circuit.

ltage difference would be zero and output zero. However the use of the 470k and 10k control allows a small potential difference to be applied across the op-amp inputs and upset the balance of the circuit. This is amplified causing the op-amp output to swing to full supply voltage and light the LED`s. The probes should first be connected to a resistor of value between 0. 22 ohm and 4ohm. The control is adjusted until the LED`s just light with the resistance across the probes. The resistor should then be removed and probes short circuited, the LED`s should go out. As the low resistance value is extremely low, it is important that the probes, (whether crocodile clips or needles etc) be kept clean, otherwise dirt can increase contact resistance and cause the circuit to mis-operate. The circuit should also work with a MOSFET type op-amp such as CA3130, CA3140, and JFET types, e. g. LF351. If the lED`s will not extinguish then a 10k preset should be wired across the offset null terminals, pins 1 and 5, the wiper of the control being connected to the negative battery terminal. A pin out for the 741 can also be found on my practical section.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

voltage inverter
Pic-plot2: a GPIB to USB converter
sensor Arduino analog signal read problem
magnetic switch circuit
Liquid-Crystal Display (LCD) Tester
U-110 1.5 Mhz Current Mode Ic Controlled 50-watt Power Supply
555 IC Square Wave Oscillator circuit
Versatile Micropower Battery Protector
parallel inverter
Table circuit voltage electric lines
200 meters remote control schematic design



Top