DMX Lighting System


Posted on Feb 5, 2014

The momentary switch used was rated for 10A for safty. If the switch was rated for too small a current, the instantaneous current for the first millisecond would fuse the switch contacts together. To achieve objective 3, some sort of switch that can vary current must be used. The posibilities are potentiometer, pulse width modulation,


DMX Lighting System
Click here to download the full size of the above Circuit.

or a triac circuit (light dimmer). The light dimmer is represented by the potentiometer in the schematic diagram. The only problem with this circuit is that there is no on/off switch any more. To incorporate an on/off switch, I have chose to place it in series with the dimmer (shown below).




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Drive an RGB led with software PWM
DIY Digital Thermometer
Antenna Low Power RF & Wireless Connectivity
50mhz 300w mosfet amplifier circuit
maximum minimum voltage indicator
ir remote switch circuit
Simple light delay circuit 3



Top