DOGM128 with Arduino Hardware


Posted on Feb 7, 2014

The Dogm-graphics-module should be connected to the Arduino board as shown below. Pin 12 (MISO) of the Arduino board must not be used. Additionally the Dogm-graphics-module requires an addess line (A0) which can be connected to any output port. The following schematic shows the use of the dogm-graphics-module with a 3. 3 volt supply. The level tran


DOGM128 with Arduino Hardware
Click here to download the full size of the above Circuit.

slation (5 volt to 3. 3 volt) is done by the HC4050 integrated circuit.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Single Supply RS232 Interface for Bipolar AD converters
    Optical-pick-up-tachometer
    Air-motion-detector
    Car Speed Alarm Schematic
    HiFI Headphone Amplifier
    Assembly of the F&DARC Square Wave Generator/Bridge
    Four-Channel Oscilloscope Adaptor
    PIC Stepper Motor Tester
    Digital Lock Project
    AM circuit by MC1496



    Top