Digital Controlled Precision Amplifier Circuit PCB


Posted on Feb 5, 2014

Here is a circuit of a precision amplifier with digital control can be useful for signal conditioning of low output transducers in milli volt range. The resistors R3 to R6 can be selected by the user and can be anywhere from 1 kilo-ohm to 1 meg-ohm to select the appropriate gain of the precision amplifier. C1 reduce ripples in the voltage and Z1 an


Digital Controlled Precision Amplifier Circuit PCB
Click here to download the full size of the above Circuit.

d Z2 limits input voltage to +- 4. 7V Precision amplifier circuit shown in figure, The IC1 opamp us used to increase the input impedance to avoid floating of the inputs when no measurement is being made. IC5 is used to restore the polarity of the input and works as an inverting buffer amplifier while IC4 is an output buffer. Eight steps for gain or attenuation can be added by using two CD4051/52




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Frequency Generator circuit
    Intercom
    Wideband Preamp Circuit
    Motorola SN54 Demultiplexer Logic Diagram and Datasheet
    TX-300 300mW FM Transmitter
    Solar Charger Schematic
    voltage regulator circuit with pass
    chip programmer
    atm8 prg
    radio controlled electronic flash
    active loudness circuit schematic
    200m fm transmitter simple circuit
    40 m band direct conversion
    Unipolar Stepper Motor Controllers
    Tone Control Circuit
    PC 12V Adapter
    Closed loop speed control of DC motor using back emf sening



    Top