Door open alarm using 555 timer circuit


Posted on Feb 5, 2014

This door open alarm electronic project is designed using an linear hall effect device and a 555 timer circuit. This door open alarm alarm electronic project is based on the TL3103 linear hall effect device used for detecting the angle of rotation. The TL3103s are centered in the gap of a U-shaped permanent magnet. Usually a 555 timer circuit is t


Door open alarm using 555 timer circuit
Click here to download the full size of the above Circuit.

riggered by taking the trigger, pin 2, low which produces a high at the output, pin 3. In this configuration with the door in the closed position, the TL3019 output is held low. The trigger, pin 2, is connected to Vi the supply voltage Vcc. When the door opens, a positive high pulse is applied to control pin 5 through a 0. 1 uF capacitor and also to reset pin 4. This starts the timing cycle. Both the piezo alarm and the LED visual indicator are activated.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Timing-threshold-and-load-driver
Lm318 Microphone preamplifier with tone control circuit and explanation
Phoenix From Start to End
diode radio circuit
accurate reaction timer
Pulse Frequency Modulator
MOSFET-BASED PREAMPLIFIER FOR FM RADIO Project PCB
FSK Demodulator
LED TesterCircuit
Automotive Buses and Vehicle Bus Description
Night Alert
Voice Shield for Arduino
One zero trigger thyristor power adjustment circuit
500A-6V single-phase power supply circuit Thyristor electroplating
Explosive gas detector circuit diagram
Available voltage booster 400Vp-p output



Top