Economy radar detector


Posted on Feb 6, 2014

This circuit uses a 1458 dual op-amp to form a radar detector. C1 is the detector of the radar signal. The first op-amp forms a current-to-voltage converter and the second op-amp buffers the output to drive the piezo transducer. R5 sets the switching threshold of the second op-amp; normally it is adjusted so that the circuit barely triggers on bac


Economy radar detector
Click here to download the full size of the above Circuit.

kground noise, then it`s backed off a bit. The response of the circuit may be tuned by adjusting the length of the leads on C1. For typical road-radar systems, the input capacitor`s leads should be about 0. 5 to 0. 6 inches long.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    15 x 7 LED display with PIC16F628
    Very Low Noise Pick-up Preamplifier
    Automatic-fan-speed-controller
    DIY Welder Control Board
    AVR Atmega32 flash verification error
    mobile incoming call indicator
    wireless temperature sensor
    sequential led bar graph circuit
    Infrared Toggle Switch schematic diagram
    Shed/Garage Alarm
    High Voltage Generator
    Level controller circuit
    Battery discharge status indicator circuit



    Top