FM Wireless Microphone

Posted on Feb 5, 2014

Here is a very simple, inexpensive and interesting project which provides lot of fun to a home experimenter or hobbyist. This simple transmitter can transmit speech over a short range. It can be used as a simple cordless microphone. The circuit uses two integrated circuits from Maxim. IC1 a MAX4467, is an amplifier raising the microphone signal to

FM Wireless Microphone
Click here to download the full size of the above Circuit.

a level suitable for frequency modulation (FM). IC2 is a voltage-controlled oscillator (VCO) with integrated varactor (a. k. a. varicap diode). Its nominal frequency of oscillation is set by inductor L1. The inductor value 390 nH provides an oscillation frequency of about 100 MHz. For best performance, L1 should be a high-Q component. L1 may consist of 4 turns of silver-plated wire wound around a 10-mm drill bit, and stretched to a length of about 1. 5 cm. The wire diameter can be anything between 26 SWG (0. 5 mm) and 20 SWG (1 mm). No core is used. The MAX4467 is a micro-power opamp for low voltage operation and providing 200-kHz gain bandwidth at a supply current of just 24 µA. When used with an electret microphone, some form of DC bias for the microphone capsule is necessary. The MAX4467 has the ability to turn off the bias to the microphone when the device is in shutdown mode. This can save several hundred micro-amps of supply current, which can be significant in low power applications particularly for battery powered applications like cordless microphones. The MIC-Bias pin provides a switched version of Vcc to the bias components. Resistor R1 resistor limits the current to the microphone element. The output impedance of the MAX4467 is low and well suited to driving cables over distances up to 50 m. The MAX2606 intermediate-frequency (IF) voltage-controlled oscillators (VCO) has been designed specifically for portable...

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    Light Sensor Switch
    High And Low Voltage Cut Off With Time Delay
    Connecting an MSP430 to ADS1248 via SPI
    1-Wire Two-way level converter unit (from 1.8V to 5V) Reference design
    Arduino Runing On && Charging NiMH batteries
    OpAmp based Voltage Translator Ciruit for ADC of Micro-controller
    sound via laser light
    Safety / Protection Circuits
    Intro to Intan Amplifier Chips
    10x TDA1543 NOS DAC
    LED Pumpkin Candles for Colorful Halloween Jack-O-Lanterns
    Simply by remote control law circuit diagram
    FM Linear Amplifier 400mW