Flyback Transformer Drivers


Posted on Feb 6, 2014

A solid state flyback driver based on a micro solid-state Tesla coil circuit created by Steve Ward. The schematic is reprinted here with credits to Steve Ward: microsstc. jpg. NOTES ON MY DESIGN: Instead of an air-core Tesla Coil setup, I used a flyback. Also I used a IRFP450 MOSFET, which is rated about 4A less than the IRFP460 MOSFET. The transformer I used is ~30V 2A.


Flyback Transformer Drivers
Click here to download the full size of the above Circuit.

I used a standard 8-pin socket instead of two 4-pin sockets for the two ICs (TC4420 and 555 timer). This tube flyback driver is based on a vacuum tube tesla coil (VTTC) and high voltage generation circuits in tube TVs. Below is the schematic of the tube flyback driver. The 6BG6 tube is a TV output tube that drives the flyback transformer. The 12SQ7 is a high-gain amplifier that boosts the feedback signals to oscillate the 6BG6 tube. The power transformer was salvaged from a small HP frequency counter, and has 250V, 18V, and 7V windings. The 250V winding is fed in a voltage doubler which brings it up to around 600V, but drops to around 300 to 400 volts loaded. The 18V winding feeds the 6V 2. 5A filament of the 6BG6 tube, which works alright and the voltage drops to about 5V loaded. The 7V winding is fed into another voltage doubler to bring up the voltage to around 10V to 15V for the 12V filament of the 12SQ7. The circuit is self-resonant due to the use of feedback to trigger the oscillations so there is no frequency alignment necessary.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Power supply monitor
    Very Low Frequency VLF Detector Circuit
    2000v high voltage low current power
    Microphone Amp
    astable multivibrator
    Single Meter Clocks
    National LM386 Audio Power Amplifier Datasheet for Battery Operation
    Morse Code circuit using ATtiny85
    Functional Block Diagram for AD524 pin and internal circuit



    Top