Headphone amplifier with TDA2004 circuit


Posted on Feb 5, 2014

A opamp medium power, used as amplifier of headphones with possibility drive low loads. It contains in a nutshell two amplifiers. The voltage gain, has been determined in 40dB, from the R3-4 and R11-12, for each channel, respectively. The restriction of bandwidth for each unit is regulated by the combination of R12, C2 and R13, C15, in


Headphone amplifier with TDA2004 circuit
Click here to download the full size of the above Circuit.

22KHZ. The R5, R10 attend to the adaptation of impedance earphones. The resistors R6 and R9 discharge the capacitors C9 and C12, in order that when we connect the headphones in the plug, not we have annoying noise. The circuit has very good characteristics as low distortion, noise and satisfactory frequency response. The requirement of circuit in current is 150mA, roughly, with voltage supply + 15V. The IC1 should be placed on a suitable heatsink.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

PIC12C508A Beacon
Pulse Generator With Variable Duty Cycle Circuit
15dB UHF Antenna Preamp Circuit
ldr engineer
Basic Controls of a CRO
Cell Phone Operated Land Rover
simple but reliable car battery tester
XR-8038 precision frequency generator
Based on the LT3755 50W white LED headlight drive circuit diagram
A read-only phase sequence indicator circuit
Using PLL Phase Locked Loop IC frequency N 1 to 10 of the multiplier circuit



Top