High Impedance DC Voltmeter Circuit Using Op Amp


Posted on Feb 4, 2014

This is a design for a high impedance DC voltmeter. This circuit is design with built by uA741 IC. This IC is a op-amp non-inverting DC amplifier. The IC have negative feedback that is through a DC meter requiring 1mA for full scale deflection. This is the figure of the circuit. The principle work of this circuit is since R6 is 100 Ohms, the meter


High Impedance DC Voltmeter Circuit Using Op Amp
Click here to download the full size of the above Circuit.

will show full scale reading when the DC input voltage to pin3 is equal to the voltage drop across R6, viz 0. 1 volts. Choice of R1 and R2 for getting different voltage ranges are shown in the table. The diodes D1 and D2 protect the IC from accidental excessive input voltages and diodes D3 and D4 protect the meter from overloads. The circuit can be powered from a +9V/-9V dual power supply.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

60W Power Amplifier with 2N3055
2ChPre
ISL43485 3.3V Half Duplex 30Mbps RS-485/RS-422 Transceiver
LIRC receiver
DC Motor Tutorial
1930 ~ 1990MHz narrow-band RF2320 linear amplification circuit diagram
Recording circuit of phone conversations using PC



Top