LED Bike Light Circuit Project


Posted on Feb 4, 2014

First I bought another front wheel, one which has a dynamo already built in the hub. This supplied a nice sine wave of 30 Vpp (at no load). With this knowledge I designed a simple power supply. The transistors that are used are type BD911. These are a bit of an over-kill, but there were plenty of these at my school, so that is why I used them. Something a little smaller will also work.


LED Bike Light Circuit Project
Click here to download the full size of the above Circuit.

The power supply is connected to an astable multi-vibrator. This alternately drives the front light and the rear light. The frequency is determined by the RC time-constant of R3 and C3, and R2 and C4. This time can be calculated with the formula: t = R3G—C3 = 20G—103G—10G—10-6 = 0. 2 s You can use a 22k (common value) for R2 and R3, that doesn`t make much difference. On a small piece of prototyping board are six LEDs with a voltage dropping resistor in series with each pair of LEDs. Such a PCB is used for both the front and the rear of the bike. Of course, you use white LEDs for the front and red ones for the rear. The PCB with the main circuit is mounted under the seat, where it is safe and has been working for more than a year now. There are a few things I would change for the next revision. An on/off switch would be nice. And if the whole circuit was built with SMD parts it could be mounted near the front light. This would also be more convenient when routing the wiring. Now the cable from the dynamo goes all the way to the seat and from there to the front and rear lights.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Temperature Controler switch
Stereo PLL FM transmitter
Guitar and bass tuner
Broadcast band RF amplifier
Low-frequency-oscillator
Pure Sine-Wave Generator Circuit
PIC Programming how to get started
transistors Role of capacitor in this circuit
A microcontroller (MCU) is a small computer



Top