Lithium Ion Charger 2 Cell


Posted on Feb 7, 2014

The charger operates by supplying a short current pulse through a series resistor and then monitoring the battery voltage to determine if another pulse is required. The current can be adjusted by changing the series resistor or adjusting the input voltage. When the battery is low, the current pulses are spaced close together so that a somewhat con


Lithium Ion Charger 2 Cell
Click here to download the full size of the above Circuit.

stant current is present. As the batteries reach full charge, the pulses are spaced farther apart and the full charge condition is indicated by the LED blinking at a slower rate. A TL431, band gap voltage reference (2. 5 volts) is used on pin 6 of the comparator so that the comparator output will switch low, triggering the 555 timer when the voltage at pin 7 is less than 2. 5 volts. The 555 output turns on the 2 transistors and the batteries charge for about 30 milliseconds. When the charge pulse ends, the battery voltage is measured and divided down by the combination 20K, 8. 2K and 620 ohm resistors so that when the battery voltage reaches 8. 2 volts, the input at pin 7 of the comparator will rise slightly above 2. 5 volts and the circuit will stop charging. The circuit could be used to charge other types of batteries such as Ni-Cad, NiMh or lead acid, but the shut-off voltage will need to be adjusted by changing the 8. 2K and 620 ohm resistors so that the input to the comparator remains at 2. 5 volts when the terminal battery voltage is reached. For example, to charge a 6 volt lead acid battery to a limit of 7 volts, the current through the 20K resistor will be (7-2. 5)/ 20K = 225 microamps. This means the combination of the other 2 resistors (8. 2K and 620) must be R=E/I = 2. 5/ 225 uA = 11, 111 ohms. But this is not a standard value, so you could use a 10K in series with a 1. 1K, or some other values that total 11. 11K...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Telephone motor Controller
    Audio Mixer with 2N3819
    Distribution Amplifier
    Keypad Combination Lock Relay
    Logic-Level actuated gas solenoid
    humidity sensor circuit II
    Siren system circuit
    Xor-gate-up-down-counter
    Miniature-wideband-amplifier
    cheap frequency counter
    CAN bus line communication modular design of one-chip computer and MCP2510
    h bridge circuit
    HIP6302 Microprocessor CORE Voltage Regulator Multiphase Buck PWM Controller
    Wireless Transmitter
    Index 2 - Power-Supply Circuits-DC to DC - power supply circuit - SeekIC.com
    555 Rock lantern controller circuit diagram



    Top