Lm318 Microphone preamplifier with tone control circuit and explanation


Posted on Feb 5, 2014

This electronic project is a simple microphone preamplifier based on the LM318 op amp. The LM318 op amp is operated as a standard non-inverting amplifier. Resistor R1 provides an input path to ground for the bias current of the non-inverting input. The combination of R2 and C2 provides a frequency roll-off below 30 Hz. At 30 Hz and above the gain


Lm318 Microphone preamplifier with tone control circuit and explanation
Click here to download the full size of the above Circuit.

is relatively flat at about 50 dB, set by the ratio R3/R2. R3 furnishes negative feedback from the output to the inverting input of the op amp. C3 ac couples the preamp to the tone control section. The top half of the tone control section is the bass control. The bottom half controls the treble frequency response. These tone controls (R5 and R8) require audio taper (logarithmic) potentiometers. The 50 k ohm potentiometer on the output can be used to set the output or gain of the preamp. The circuit is very simple and require few electronic parts. This microphone preamplifier electronic project must be powered from a dual 15 volt DC power supply.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Cuckoo-song Generator
    Electronic Thermometer
    TDA2030 18W + 18W Stereo Hi-Fi Audio Amplifier circuit and explanation
    Variable Dc Power Supply
    IR Remote Control Modulation Detector
    220V Flashing LED Circuit
    BAR GRAPH READOUT VOLTMETER
    Circuit power audio amplifier TDA2040 20 watts integrate circuit with pcb and power supply circuit



    Top