NE 555 & LM 567 Remote Control Circuit


Posted on Feb 5, 2014

Remote control circuit consists of two parts, one is transmitter and the other is receiver. A simple diagram is schematic remote control. The transmitter circuit`s transmitter IC is controlled by NE555. Receiver circuit works by the signal emitted frequency which is emitted by that transmitter circuit. Transmitted signal frequency must be equal to


NE 555 & LM 567 Remote Control Circuit
Click here to download the full size of the above Circuit.

the frequency decoder of the receiver circuit. The NE 555 generated frequency is same that receive frequency of IC LM 567. The resistor R1 is a receiver variable to facilitate the process of tuning. The system works well when the circuit is ready. The first step is tuning by way of the transmitter is turned on continuously, while the receiver R1 to set the value to be able to detect the signal transmitter. The second part is the receiver is controlled by LM 567. The following is a schematic drawing recipient. In the picture on top of each channel is designed with a different frequency. By considering the bandwidth of the frequency detection signal LM 567, inter-frequency channels should have a big enough difference, let`s try with a difference of 5 KHz.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Speed controller 2
Motorized Remote control with ATMEGA328
Antenna ground loop Isolator
Thermometer with 10 LED scale
Sample and hold
Tube Amplifier Isolates High Voltages
Transistor Clock
USB Battery Charger for AA NiMH and NiCd
transformer Single pole AC to DC conversion circuit
wein bridge sine wave oscillator lm101
light sensor circuit using pic16c63
silicon fuzz
RF amplifier and filter for 10.7 MHz



Top