Optical Theremin


Posted on Feb 5, 2014

Normally, Thereminworks by detecting hand proximity using capacitive coupling method. A Theremin circuit shown in the schematic diagram below use different method to control the pitch. The oscillator of this tone generator, both the volume and frequency are controlled using LDRs, a light sensitive electronic component, so we can call this circuit


Optical Theremin
Click here to download the full size of the above Circuit.

anoptical Theremin. Look at the following schematic diagram: LDR1 control the frequency of this Theremin, while LDR2 control the volume level. We can place the LDR in two boxes where we can use our hand to control the aperture of the box, allowing smooth control of light amount that expose the LDR. This light is expected to come from ambient light, entering the box through the hand controlled aperture. This optical Theremin assume a stable ambient light to produce smooth control. The output will be heard on a small loudspeaker, but will be in very low volume. You can just amplify this output with a standard audio power amplifier to get better loudness.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Pine Racecar Victory Judge
    Tilt-meter
    Ac Watts Calculator Circuit
    Audio 6 Band Graphic Equaliser Using 741 Op-Amp
    Timing within the one-chip computer Counter and interrupt system
    oscillator
    solid state tesla coil circuit
    Msp430c112 Irda Sir Encoder/decoder
    Glolab 4 Bit Encoder/Decoder for Wireless and Infrared
    Full complementary symmetry amplifier CL
    Combustible gas alarm circuit



    Top