PC computer based frequency meter circuit diagram

  
Inside:
Repository
Here is a simple technique for measuring frequencies over quite a wide frequency range and with acceptable accuracy limits using a PC. It follows the basic technique of measuring low frequencies, i. e. at low frequency, period is measured for a complete wave and frequency is calculated from the measured time-period. Cascaded binary counters are use
PC computer based frequency meter circuit diagram - schematic

d for converting the high-frequency signals into low-frequency signals. The parallel port of a computer is used for data input from binary counters. This data is used for measuring time and calculating the frequency of the signal. The block diagram shows the basic connections of the counters and parallel port pin numbers on 25-pin D connector of a PC (control register 379 Hex is used for input). External hardware is used only for converting the higher frequency signals into low frequency signals. Thus, the major role in frequency-measurement is played by the software. The PC generates a time-interrupt at a frequency of 18. 21 Hz, i. e. after every 54. 92 millisecond. Software uses this time-interrupt as a time-reference. The control register of the PC s parallel port is read and the data is stored continuously in an array for approximately 54. 9 ms using a loop. This stored data is then analysed bit-wise. Initially, the higher-order bit (MSB or the seventh-bit) of every array element is scanned for the presence of a complete square wave. If it is found, its time period is measured and if not then the second-highest order bit (sixth bit) is scanned. This operation is performed till the third bit and if no full square wave is still found, an error message is generated which indicates that either there is an error in reading or the frequency signal is lower than 19 Hz. Lower three bits of the control register are not used....



Leave Comment

characters left:

New Circuits

.