RF Amplifier circuit with 2SC1970 2N4427 Schematic Diagram


Posted on Feb 6, 2014

RF power amplifier circuit of this work is based on the transistor 2SC1970 and 2N4427. The set output power of 88-108 MHz FM RF Amplifier With 2SC1970 is about 1. 3W and the input driver is 30-50mW. RF driver amplifier circuit uses a 2N4427 and its power amplifier using a transistor 2SC1970. At the time of the amplifier circuit tuning FM 88-108 MHz


RF Amplifier circuit with 2SC1970 2N4427 Schematic Diagram
Click here to download the full size of the above Circuit.

RF Amplifier With 2SC1970 should use the power meter / watt meter or SWR or RF field can also use the meter. RF amplifier circuit can work from the frequency of 88-108 MHz. Circuit of 88-108 MHz FM RF Amplifier With RF 2SC1970 can radiate far enough. At the time of tuning you should use a 50 Ohm dummy load. For the input signal should be installed to regulate the VR level so as not to over-modulation (30-50mW). You are reading the Circuits of RF Amplifier circuit with 2SC1970 2N4427 And this circuit permalink url it is




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Cheap 12V to 220V Inverter
    Differential Light
    intercom circuit with transistors
    Deluxe Charge Rate Limiter for Small Capacity NiCad Batteries
    R/C-Plane altitude recorder
    10W audio amplifier with TDA2003
    Switchable Output Crystal Oscillator
    O2 Input 0-5v Modification
    50hz Calibration aid for Multimeters



    Top