RF Module Interfacing Circuit Example


Posted on Feb 6, 2014

I am posting here a circuit example for interfacing RF module using HT12E/D encoder decoder pair. The circuit attached here can be used to transfer data using the RF module. As I have explained earlier RF module mentioned here is having a single channel. So we can use only serial data transfers. This example uses HT12E/D encoder-decoder pair for converting the parallel data to serial and back.


RF Module Interfacing Circuit Example
Click here to download the full size of the above Circuit.

This encoder-decoder pair supports 4 bit parallel data. Thecircuithas two parts transmitter and receiver. In the transmitter part we are using HT12E for encoding data from parallel to serial. The serial output from the from the encoder is fed to the data IN of the RF transmitter. Four switches namely SW0, SW1, SW2, SW3 are used to input data to the decoder. These switches are pushbutton switches with active low states. (i. e. when you press it, the data input will be `0` and in the released state data input will be `1`. The default state is `1`). At the receiver section we are having RF receiver and HT12D decoder IC. The serial data from the receiver is fed into to serial input of the decoder. The parallel data is displayed with the help of LED`s. AnotherLED at the pin VT of the decoder shows whether your link is established or not. If it is ON then everything is OK. Instead if it ispermanently OFF, then there is a linkfailure. You may refer the data sheet of the IC to know the exact function of pin VT. After eachsuccessfultransmission of a 4-bit data, VT pin goes to a low state for a while and will come back to high state. Thus during the transmission you may see the LED at pin VT blinking. If your circuit is not working, just remove the RF transmitter and receiver and make a wired connection from the serial data OUT of the HT12E encoder to the serial data IN of the HT12D decoder. Now check whether you could receive the...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Tunable IF with TDA7000
    3 Way Crossover -24dB
    General-Purpose 5W Audio Amplifier With Ac Power Supply
    Maximum Load Capacitor that LMV116 can drive
    loop antennas
    Temperature controller circuit



    Top