RJ45 Network card to IR communication


Posted on Feb 5, 2014

This system, composed of two opto-insulated circuits, allows the data transmission per infra-red network device between two computers. For example, someone can transfer his files starting from his desktop computer to his laptop computer without using any cable. How By using infra-red diodes. We have to connect a circuit to the 10/100 Mbps network


RJ45 Network card to IR communication
Click here to download the full size of the above Circuit.

card of both computers by using a very small network cable (can be smaller than 10 cm). One of the two extremities of the cable must be removed to allow the wire connections. We must pay attention when we do the connections. The Tx+ output of any network card is connected to the input of the Rx+ of the other with the cable. It`s the same way for the Tx- and the Rx-. We have to supply the circuits with two sources of voltage. I recommend to use a 9V battery and the +5V output of the power supply for the desktop computer. The ground of the power supply must be connected to the ground of the circuit. For the laptop computer, I recommend to use a 9V battery and the 4. 5V battery. All digital components must be of the 74H series because these have short response times (less than 2. 5 ns). All the GND pins of the logic integrated circuits must be connected to the ground of their circuit and their Vcc pin must be connected to the +Vcc of their circuit.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Programmable Inverter/Rectifier
    Simple digital frequency meter
    Simple Sixteen Stage Bi-Directional LED Sequencer
    laser sup circuit
    dc motor control circuit
    Creating an HID Ballast with Constant Lamp Power Control
    LM 3875



    Top