Rear Fog Lamp For Vintage Cars


Posted on Feb 7, 2014

According to current legislation in many countries, vintage cars must also be fitted with a fog lamp at the rear. In modern cars, there is a bit of circuitry associated with the fog lamp switch to prevent the fog lamp from going on when the lights are switched on if the driver forgot to switch it off after the last patch of fog cleared up. The cir


Rear Fog Lamp For Vintage Cars
Click here to download the full size of the above Circuit.

cuit described here extends that technology back in time. The circuit is built around a dual JK flip-flop (type 4027). T3 acts as an emitter follower, and it only supplies power to the circuit when the lights are switched on. For safety reasons, the supply voltage is tapped off from the number plate lamp (L2), because it is on even if you accidentally drive with only the parking lights on. The wire that leads to the number plate lamp usually originates at the fuse box. As the states of the outputs of IC1a and IC1b are arbitrary when power is switched on, the reset inputs are briefly set high by the combination of C1, R1 and T1 when the lights are switched on (ignition switch on). That causes both Q outputs (pins 1 and 15) to go low. IC1a and IC1b are wired in toggle mode (J and K high). The Set inputs are tied to ground (inactive). The driver uses pushbutton switch S1 to generate a clock pulse that causes the outputs of the flip-flops to toggle. The debouncing circuit formed by C2, R4 and T2 is essential for obtaining a clean clock pulse, and thus for reliable operation of the circuit. C1 and C2 should preferably be tantalum capacitors. The Q output of IC1b directly drives LED D1 (a low-current type, and yellow according to the regulations). The Q output of IC1a energises relay Re1 via T4 and thus applies power to the rear fog lamp L1. Free-wheeling diode D2 protects T4 against inductive voltage spikes that occur when the...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Load detector Mains Switch
    Car Battery Charger12V circuit and explanation
    CSC231 Homework
    Launchpad plus LCD equals serial terminal
    Daewoo Korando Front and Rear Fog Lamp Schematic and Routing Diagrams
    Thermometer with PIC Microcontroller
    avr programmer how to make
    12 V Florescent lamp driver circuit
    How To Build A Simple Code-Operated Switch
    100kHz-30MHz active antenna circuit diagram
    15W Valve Modulator Amplifier circuit



    Top