Room Noise Detectors


Posted on Feb 6, 2014

This circuit is intended to signal through a flashing LED, the exceeding of a fixed threshold in room noise, chosen from three fixed levels, namely 50, 70 & 85 dB. Two Op-amps provide the necessary circuit gain for sounds picked-up by a miniature electret microphone to drive a LED. With SW1 in the first position the circuit is off. Second, third a


Room Noise Detectors
Click here to download the full size of the above Circuit.

nd fourth positions power the circuit and set the input sensitivity threshold to 85, 70 & 50 dB respectively. The 50 dB setting is provided to monitor the noise in the bedroom at night. If the LED is steady on, or flashes bright often, then your bedroom is inadequate and too noisy for sleep.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    dual-trace scope switch
    Broadcast-band-rf-amplifier
    Powering Your Antique Battery Radio
    Transformerless Voltage Booster Circuit: A DC-DC Step-Up Switching Regulator Using Transistors
    bypass which improves the ability to resist surging of relay contact
    bi directional level shifter
    building regulated 5v dc power supply
    Capacitive Touch Sensor
    Chizuru 100Hz channel frequency pulse charging electric bike battery circuit
    Single-phase full-wave rectifier circuit 02 phase



    Top