SP6336 SP6336 -Triple Micropower Supervisory Circuit With Watchdog And Power Fail


Posted on Feb 7, 2014

Introduction The SP6648 integrated synchronous boost Regulator is a compact circuit that provides a ultra- high efficiency drive current for an LED flashlight using a LuxeonTM I light source. The circuit shown below is configured to provide 350mA constant output current for a two cell alkaline battery application. All components are compact surfac


SP6336 SP6336 -Triple Micropower Supervisory Circuit With Watchdog And Power Fail
Click here to download the full size of the above Circuit.

e mount devices, yielding a tiny final solution. Diode D1 has been added to reduce the effective feedback voltage from 1. 25V down to 0. 61V to improve efficiency. The LED current CAN be programmed as high as 900mA depending on the set resistor value. Operating quiescent current of the part is only 12uA, so only a negligible amount of power is used by the part itself. The SP6648 is available in MSOP for easy pin access in proto- type and testing, and also 3x3mm DFN for the smallest production circuit.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Low-noise broadband amplifier
    Bird Feeder Monitor Circuit
    active filters
    hydraulic
    laser diy schematics
    Efficient Fan Speed Controller
    Voltage follower
    OverUnity Lead Acid Battery Switching Self Battery Charging
    UPDATED ST-5 MAINLINE DEMODULATOR
    Fastest Quiz Bell/Alarm
    Bassman Modifications
    Three-phase stepper motor control circuit
    Lantern controller circuit diagram of a non-contact



    Top