Schematic Diagram circuit andexplanation


Posted on Feb 5, 2014

This power inverter circuit will provide a very stable Square Wave  Output Voltage. Frequency of operation is determined by a pot and is normally set to 60 Hz. Various off the shelf  transformers can be used. Or Custom wind your own for best results. Additional MosFets can be paralleled for higher power. It is recommended to Have a Fuse  in


Schematic Diagram circuit andexplanation
Click here to download the full size of the above Circuit.

the Power Line and to always have a Load connected , while power is being applied. The Fuse should be rated at 32 volts and should be aproximately 10 Amps per 100 watts of output. The Power leads must be heavy enough wire to handle this High Current Draw! appropriate Heat Sinks Should be used on the RFP50N06 Fets. These Fets are rated at 50 Amps and 60 Volts. Other types of Mosfets can be substituted if you wish. There ARE Limitations! I have had numerous requests for an Inverter for 1000 watts and Even MORE. Sorry I Don`t feel this is Practical. At 1000 Watts and operating from a 12 Volt Source, the Input Current will be close to 100 AMPS. That would Require a HUGH Size of a Primary Wire.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Phone line indicator using BF256B
Electronic Siren with 2 transistors
DVI to PAR digital video interface with LCD
Temperature-reporting-digital-thermometer
Car Headlight Control
burglar alarm using ic timer 555556
led chaser provides three game
Philco Portable
IC Encoder Chip
Hazard lights Coupe 1995
SDS Labs Schematics Archive



Top