Simple JFET Preamp


Posted on Feb 5, 2014

The following is an example for a very simple and high quality JFET preamp. You can use this to amplify a very low signal sources. FET transistors are usually not used independently in preamplifiers. In most of the cases they are paired with bipolar transistors. R2 automatically sets the bias for Q1 in a way similar to a tube circuit. This resisto


Simple JFET Preamp
Click here to download the full size of the above Circuit.

r tides the gate of Q1 to ground and sets its potential. Source`s potential is higher than ground by the voltage across R4 and R5. In other words the gate is more negative then the source. The gate-source transition represents a normal PN junction. Usually this junction is tied in opposite direction, which explains the relatively high input impedance (more than 109 ©). Basically the input impedance of the circuit is set by R2 and in this case it`s around 1M ©. R4 and R6 form an AC negative feedback. R1 and R7 serve as over voltage limiters and over current limiters in case of short circuit at the input or output. Besides their high input impedance, the FET transistor preamps have one more advantage. This is the very low noise. This means that we can easily design a stage with high S/N ratio. Considerable deviations from these values will cause the stage not to perform as it should be. 0V at the collector of Q2 means that there is a break into collector-emitter junction while 12V means there is a short between those two outputs. The voltage at the base of Q2 is equal to one voltage drop of a normal junction which is about




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Automatic-headlight-delay
    Dc-gain-controlled-video-amplifier
    Four-Input Minimum Maximum Selector Circuit
    6W Morse-Code Transmitter 7Mhz Circuit
    Digital Remote Thermometer
    avc serial to i2c bridge
    Monostable 555 Multivibrator Working Principle and Circuit diagram with Animation
    Muti-channel audio mixer circuit based on LM3900 IC. Four channels
    Infra Red Remote Control
    ujt triggering circuit
    POWER MOSFET INVERTER



    Top